If titanium screws fail, not only are they broken, but there are also many other faults. Below, we will analyze the reasons and solutions for the sliding of titanium screws.

The reason for the sliding of titanium screws:

1. The surface hardness of the screw is too low, the thread is too shallow or the root line is too shallow;

2. The wind turbine is too large;

3. The pore system is too large;

4. The tightening of wind turbines is still continuing to tighten;

5. The surface wind batch is not handled properly;

6. Improper tightening sequence of titanium screws leads to misaligned fixing holes, requiring too much tightening force and making it difficult to grasp;

7. The screw specification model is incorrect.

Solution for titanium screws slipping:

1. Replace screws of the same type from different manufacturers or batches. If they cannot be replaced, adjust the small air batch booth;

2. Reasonable small wind speed variable position, especially the repair of some vulnerabilities;

3. Replace or modify the system section;

4. Strengthen vocational training and master standardized usage; Strict process specifications;

5. Adjust the sequence of screw connections and try to use diagonal fixation to effectively reduce tightening force;

6. Use the correct standard screw.